American Standard S8X1 furnace code E08: Low flame current
Professional repair
What does E08 mean on an American Standard Silver S8X1 gas furnace display? E08 means flame current is low, below the 0.5 microamp DC threshold in the detailed diagnostics. The furnace is still allowed to operate; this is not a lockout.
This condition involves the gas or combustion side. If you smell gas or a CO alarm sounds: leave, then call your gas utility. Diagnostic info here is reference — combustion repairs are for licensed technicians. All six emergency signs →
A technician measures flame current and inspects the sensor, burners and related wiring. Sensor removal or cleaning is not homeowner work.
Possible causes
- Flame sensor condition reducing the measured flame current TECH
- Dirty burners producing a weak or unstable flame TECH
Parts for this code
No model-verified part number is listed here. Have the fault diagnosed and the correct part matched to your furnace before ordering.
Questions about this code
What does E08 mean on an American Standard Silver S8X1 gas furnace display?
E08 means flame current is low, below the 0.5 microamp DC threshold in the detailed diagnostics. The furnace is still allowed to operate; this is not a lockout.
How do I fix American Standard S8X1 furnace code E08?
Schedule service while the furnace is still heating. Note any short or uneven heating cycles. The technician restores adequate flame current based on what the measurement and inspection show.
How much does it cost to fix American Standard S8X1 furnace code E08?
Since the furnace still runs, this can be scheduled rather than treated as an emergency. Cost covers flame-current testing plus whatever sensor, burner or wiring service is confirmed.
Applies to
S8X1A040M3PSCA · S8X1B040M2PSCA · S8X1B060M4PSCB · S8X1B080M4PSCB · S8X1C080M5PSCA · S8X1C100M5PSCB · S8X1D120M5PSCA
Different American Standard generations use different code maps. If your series isn't listed, don't assume this meaning — check your blower-door label.
Verified against Installation, Operation, and Maintenance — Upflow/Downflow/Horizontal Gas-Fired,1–Stage and2–Stage Induced Draft Furnaces with High Efficiency Motor, p.59
Verified against Installation, Operation, and Maintenance — Upflow/Downflow/Horizontal Gas-Fired,1–Stage and2–Stage Induced Draft Furnaces with High Efficiency Motor, p.75
Verified against Installer’s Guide — Upflow/Downflow/Horizontal Gas-Fired,1–Stage and2–Stage Induced Draft Furnaces with High Efficiency Motor, p.58
Last verified 2026-10-07 · page updated 2026-10-07 · how we verify
Related American Standard furnace codes
These codes use the same american standard silver s8x1 furnace control display (2024 iom) system.