Bryant furnace code 33: Limit Circuit Fault
Try DIY first, then call a pro
Bryant furnaces share the Carrier control platform — this code table applies to the equivalent Bryant models. Confirm against your unit's panel label.
What does code 33 mean on a Bryant furnace? A limit, draft safeguard, flame rollout, or blocked-vent switch is open. The blower runs 4 minutes or until it closes; open >3 minutes escalates to lockout code 13. Rollout and BVSS switches need a manual reset.
This condition involves the gas or combustion side. If you smell gas or a CO alarm sounds: leave, then call your gas utility. Diagnostic info here is reference — combustion repairs are for licensed technicians. All six emergency signs →
GOOD NEWS: THE FIRST CHECKS ARE FREE AND TAKE MINUTES.
Try these first — in this order
Filter + every vent open — 5 minutes, the most common self-fix.
If the rollout switch tripped, get a tech before resetting anything. DIY part cost: $5–25 / $10–25 — a pro visit for this class of fault typically runs $150–350.
What causes it (in order of likelihood)
- Dirty filter or restricted ducts (official first cause) DIY-CHECKABLE
- Restricted vent, excessive wind, loose blower wheel TECH
- Defective blower motor or capacitor TECH
- Inadequate combustion air → flame rollout switch open (CO-risk signal) TECH
Parts referenced by this code
Always match parts against your model's parts list — part numbers vary within a series.
Questions about this code
What does code 33 mean on a Bryant furnace?
A limit, draft safeguard, flame rollout, or blocked-vent switch is open. The blower runs 4 minutes or until it closes; open >3 minutes escalates to lockout code 13. Rollout and BVSS switches need a manual reset.
How do I fix Bryant furnace code 33?
Stop troubleshooting and arrange a technician visit. Never reset rollout or blocked-vent switches yourself; a technician must find the cause. If a CO alarm sounds, leave and call from outside.
How much does it cost to fix Bryant furnace code 33?
A dirty filter may be inexpensive to fix. Other causes, including vent restrictions, blower problems, or a rollout trip, need a technician's diagnosis before cost is known.
Applies to
Bryant 310/311/312 series
Different Bryant generations use different code maps. If your series isn't listed, don't assume this meaning — check your blower-door label.
Same control platform, same code: Carrier furnace code 33 · Payne furnace code 33
Verified against Carrier 58STA/58STX Installation & Service Instructions (1106202L), p.37/48
Bryant 310/311/312 series furnaces use the Carrier 58STA/58STX control platform. No separate Bryant service document is cited — confirm the code map against your unit's panel label.
Last verified 2026-07-06 · page updated 2026-10-03 · how we verify
Related Bryant furnace codes
These codes use the same status led — short + long flash codes system.