Goodman GMEC96 furnace 6 red flashes: Pressure Switch Cycle Lockout
Try DIY first, then call a pro
What do 6 red flashes mean on a Goodman GMEC96 furnace? The pressure-switch signal dropped out often enough during a heat cycle that the GMEC96 control locked the furnace out. This points to an intermittent draft problem rather than a steady switch state.
Before you touch anything: the six signs that mean stop troubleshooting and call a pro →
Homeowner checks for Goodman GMEC96 furnace 6 red flashes
This is a limited outdoor observation check, not a complete furnace repair. If you smell gas or a carbon monoxide alarm sounds, leave the home right away without operating any switches, then call the gas utility or 911 from outside. Never bypass a safety switch or reset the furnace over and over.
- Turn the furnace off
Turn off the furnace at the thermostat and its nearby power switch before checking the vent ends. Keep the furnace cabinet closed.
- Find the vent ends from ground level
Locate the furnace intake and exhaust pipe ends where they leave the house. Only check ends you can see and reach while standing on the ground. Do not climb a ladder or go onto the roof.
- Clear loose snow or leaves by hand
If it is safe to stand there, brush away loose surface snow or leaves from around the openings by hand, without tools. Do not reach into the pipes, chip at ice, or remove or modify any pipe, cap, or screen.
- Stop and call if anything else is wrong
Leave the furnace off and call a technician if you find ice, a nest, a damaged pipe, or anything you cannot clear safely by hand. After clearing only loose surface snow or leaves, restore power and observe one heating cycle. If the code returns, turn the furnace off and arrange service.
Recurring six-flash lockouts require draft-pressure and inducer testing. DIY part cost: $25–60 — a pro visit for this class of fault typically runs $150–350.
What causes it (in order of likelihood)
- Loose, cracked, wet, or partially blocked pressure-switch hose DIY-CHECKABLE
- Blocked intake, exhaust, or condensate drain DIY-CHECKABLE
- Weak inducer or failing pressure switch TECH
Parts referenced by this code
Always match parts against your model's parts list — part numbers vary within a series.
Questions about this code
What do 6 red flashes mean on a Goodman GMEC96 furnace?
The pressure-switch signal dropped out often enough during a heat cycle that the GMEC96 control locked the furnace out. This points to an intermittent draft problem rather than a steady switch state.
How do I fix Goodman GMEC96 furnace 6 red flashes?
From ground level, check the outdoor vent ends and clear loose snow or leaves by hand if safe. Hose, drain, inducer, and switch checks need a technician.
How much does it cost to fix Goodman GMEC96 furnace 6 red flashes?
If a blocked vent end was the cause, clearing it may be enough. Otherwise cost depends on the results of draft-pressure and inducer testing.
Applies to
GMEC96
Different Goodman generations use different code maps. If your series isn't listed, don't assume this meaning — check your blower-door label.
Verified against Goodman GMEC96 Service Manual, p.53
Last verified 2026-07-06 · page updated 2026-10-03 · how we verify
Related Goodman furnace codes
These codes use the same gmec96 tri-color control — red fault flashes system.