HVAC●FAULTS
PAYNE DIAGNOSTIC REFERENCE STATUS LED — SHORT + LONG FLASH CODES DOC PAYNE-23

Payne furnace code 23: Pressure Switch Did Not Open

YOUR LIGHT: 2 SHORT + 3 LONG FLASHES — MATCH IT ABOVE

Professional repair

Payne furnaces share the Carrier control platform — this code table applies to the equivalent Payne models. Confirm against your unit's panel label.

What does code 23 mean on a Payne furnace? Official: obstructed pressure tubing or a pressure switch stuck closed.

Before you touch anything: the six signs that mean stop troubleshooting and call a pro →

GOOD NEWS: THE FIRST CHECKS ARE FREE AND TAKE MINUTES.

Try these first — in this order

Inspect/clear the tubing.

1Check: Obstructed pressure tubing
Still showing the code? See every cause ↓ Get repair quotes near you

Switch replacement. DIY part cost: $30–60 — a pro visit for this class of fault typically runs $150–350.

What causes it (in order of likelihood)

  1. Obstructed pressure tubing DIY-CHECKABLE
  2. Switch stuck closed TECH

Parts referenced by this code

Pressure Switch
$30–60 · Model-specific

Always match parts against your model's parts list — part numbers vary within a series.

Questions about this code

What does code 23 mean on a Payne furnace?

Official: obstructed pressure tubing or a pressure switch stuck closed.

How do I fix Payne furnace code 23?

These parts are inside the furnace, so there's no homeowner check. A technician should inspect the tubing and test the switch; never bypass it.

How much does it cost to fix Payne furnace code 23?

Cost depends on whether clearing the tubing solves it or the switch needs replacing. A technician's inspection determines which.

Applies to

Payne PG8M series

Different Payne generations use different code maps. If your series isn't listed, don't assume this meaning — check your blower-door label.

Same control platform, same code: Carrier furnace code 23 · Bryant furnace code 23

Verified against Carrier 58STA/58STX Installation & Service Instructions (1106202L), p.37/48

Payne PG8M series furnaces use the Carrier 58STA/58STX control platform. No separate Payne service document is cited — confirm the code map against your unit's panel label.

Last verified 2026-07-06 · page updated 2026-10-03 · how we verify

Related Payne furnace codes

These codes use the same status led — short + long flash codes system.

See all Payne furnace fault codes →

All furnace codes