Payne furnace code 14: Ignition Lockout
Try DIY first, then call a pro
Payne furnaces share the Carrier control platform — this code table applies to the equivalent Payne models. Confirm against your unit's panel label.
What does code 14 mean on a Payne furnace? The system failed to ignite and prove flame in 4 attempts. Auto-resets after 3 hours. Root causes = see code 34.
This condition involves the gas or combustion side. If you smell gas or a CO alarm sounds: leave, then call your gas utility. Diagnostic info here is reference — combustion repairs are for licensed technicians. All six emergency signs →
GOOD NEWS: THE FIRST CHECKS ARE FREE AND TAKE MINUTES.
Try these first — in this order
Clean the flame sensor, then watch an ignition attempt.
Gas pressure and valve work. DIY part cost: $8–18 — a pro visit for this class of fault typically runs $150–350.
What causes it (in order of likelihood)
- Everything under code 34 — flame sensor first DIY-CHECKABLE
Parts referenced by this code
Always match parts against your model's parts list — part numbers vary within a series.
Questions about this code
What does code 14 mean on a Payne furnace?
The system failed to ignite and prove flame in 4 attempts. Auto-resets after 3 hours. Root causes = see code 34.
How do I fix Payne furnace code 14?
Note how often it happens. Flame sensor, igniter, gas valve, and gas-pressure checks are technician work. Avoid repeated resets; if you smell gas, leave and call from outside.
How much does it cost to fix Payne furnace code 14?
Cost depends on what prevented ignition, from a flame sensor needing attention to gas pressure or valve work. A technician's diagnosis is needed first.
Applies to
Payne PG8M series
Different Payne generations use different code maps. If your series isn't listed, don't assume this meaning — check your blower-door label.
Same control platform, same code: Carrier furnace code 14 · Bryant furnace code 14
Verified against Carrier 58STA/58STX Installation & Service Instructions (1106202L), p.37/48 — “System failed to ignite gas and prove flame in 4 attempts. See status code 34”
Payne PG8M series furnaces use the Carrier 58STA/58STX control platform. No separate Payne service document is cited — confirm the code map against your unit's panel label.
Last verified 2026-07-06 · page updated 2026-10-03 · how we verify
Related Payne furnace codes
These codes use the same status led — short + long flash codes system.